How to Rewind and Remove Film from the Canon T50

This page will cover the steps needed to rewind and remove a roll of 35mm film from the Canon T50. If you need help with loading film into the camera see this step-by-step guide on how to load film into the Canon T50.

While the Canon T50 needs two AA batteries to work, it does not need batteries to be able to rewind the film.

Time needed: 1 minute.

Here are the steps you need to follow to rewind and remove the film from your Canon T50. These steps can also be used to remove a roll of film before all of the exposures have been used. For demonstration purposes, I am using a roll of film that was left in a used camera and exposed.

  1. Push the take-up spool unlock button on the bottom of the T50.

    Push the small silver button on the bottom of the camera. It is located near the serial number. This will unlock the take-up spool and allow you to wind the film back into the canister.

    Canon T50 Take-up Spool Unlock Button

  2. Fold out the lever on the rewind knob and turn clockwise.

    This will wind the film back into the 35mm film canister. You will feel the resistance lessen when all of the film has been wound off the take-up spool. Give it a few more turns after that and all the film will be in the canister.

    Canon T50 Film Rewind Lever

  3. Open the film door.

    Pull up on the film rewind knob to open the film door. It will pop open. Leave the rewind knob raised.

    Canon T50 Open Film Door

  4. Remove the film canister from the Canon T50.

    The easiest way to remove the film canister is to let gravity do the work. Tilt the entire camera and the film canister should just fall out. If it doesn’t, pull the film rewind knob up further.

    Canon T50 Remove 35mm Film Canister

  5. Load another roll of film.

    Now is the best time to load another roll of film into the camera. Here is a step-by-step guide on how to load film into a Canon T50.

    If you don’t have another roll of film, you can just close the back of the camera. For long-term storage, remove the batteries so they do not leak and cause corrosion on the battery contacts, which can ruin the camera.

There are 3 different ways you can get your film developed.

The least expensive and most involved way to develop your film is to do it yourself at home. This is what I prefer to do.

You will need some inexpensive equipment and a way to scan your negatives or slides.

Developing film yourself is definitely worthwhile as long as you are consistently shooting film. If you are only going to occasionally shoot film, mailing it to a lab is going to be less expensive.

There are many photo labs that offer mail in developing and scanning services. What’s nice is that you’ll get your film scanned using a high-end scanner. This is a big time saver.

Another important aspect is that you’ll get your negatives or slides back from the lab. This will allow you to make prints in a darkroom or re-scan them in the future. Plus they act as a physical back-up.

Depending on the lab you choose, you can have the ability to select the machine that does the scanning and any profiles/corrections that get used.

You can also indicate if film has been pushed or pulled so that it can be processed correctly.

Here is a list of US photo labs that offer mail developing services. I have no affiliation with them and I have not used any of their services.

A local lab is a good option as long as it is an independent professional photo lab. These are likely going to be limited to large cities.

The labs located in pharmacies or big box stores are the worst option as they no longer develop the film on location.

What happens is that the pharmacy or big box store will mail the film off to get developed by a third party. You will only receive digital copies of your images. You will not get your negatives or slides back.